Dallas Restaurant Hood Cleaning Services.

214-697-1342​

​​100% satisfaction guarAnteed.

​​24 x 7 service & emergency service.

State of the art cleaning equipment.

hoods cleaned to nfpa 96 standards.

certified, trained, insured technicians.

Complete Kitchen Hood cleaning service.

​The (NFPA-96) requires commercial food processing facilities and all restaurants to install hinging systems on their roof top ventilators;  We sell and install hinge kit solutions from the top manufactures.  Our Exhaust Fan Hinges are the ultimate solution to any challenge commercial cooking and restaurant operation.
Proper exhaust fan cleaning. In order to thoroughly clean any commercial kitchen exhaust fan a sturdy hinging system must be installed to safely access all areas for proper cleaning.

Safety. Trying to remove a heavy exhaust fan from its duct for cleaning or maintenance is not only dangerous for the contractor but always causes some degree of damage to the roof or the fan housing.

To protect the fan wiring. Exhaust fan wiring is stretched when the fan is taken off the stack and placed on the roof. Without a hinge kit, the fan wiring is subject to unnecessary abuse during cleaning and maintenance.

To protect the exhaust fan. The exhaust fan can be damaged over time by removing it from the stack repeatedly and placing it on its side.

To prevent roof damage. Rooftop damage and leaks can be the result of placing the exhaust fan on the roof during cleaning or maintenance.

It’s the Law! NFPA 96 Code 8.1.1.1 states: "Approved up-blast fans with motors surrounded by the air stream shall be hinged, supplied with flexible weather proof electrical cable and service hold-open retainers, and listed for this use."


DFW Hood Cleaning is proud to offer the Super Hinge from Omni Containment Systems. The Super Hinge changes the way exhaust fans are hinged for cleaning and maintenance.

The Omni Super Hinge's patented technology allows for ease, convenience, versatility and durability, and helps increase the life of the expensive fan housing by adding support to prone failure areas of the fan base.Laser cut heavy gauge powder coated steel components eliminate the repetitive flexing stress that occurs to fan base during use and service. Corrosion proof hardware is provided to ensure that the Super Hinge stays firmly attached to the fan and duct.